Answer / subhasbabu

FOR SLAB FOR MAIN BAR 3 TIMES THE DIAMETER AND 5 TIMES FOR
DISTRUBUTION BAR, BUT IN THE CASE OF BEAM MAXIMUM SIZE OF
AGGREGATE, AND MINIMUM BARS 2NOS FOR MAIN REINFORCEMENT

Answer / piyush singh

slab : maximum spacing should not exceed

main steel = 3 * dia or 300
distribution = 5 * dia or 450

as per IS 456

Answer / lear

for slab 150mm and for beam 200mm

Answer / puspendu shyamal

minimum spacing required- (a)Diameter of the bar if the diameter is equal,(b)Diameter of the largest bar if diameter is unequal,(c)5mm more than the size of the aggregate,which ever is greater.

Answer / prakash vaishnav

for slab 125mm and for beam 200mm

how to nfind out the specific gravity of sand.aggregate,water please help...

0 Answers  

how much steel provide in 1m cube r.c.c

3 Answers  

develpement lengh

1 Answers   Sobha Developers,

what is the ideal construction joint for slab?

2 Answers  

I used Etabs software to analyse a high-rise building. And I want to use templated UBC-codes inside to calculate the Seismic load. My question is: whether or not I have to control the seismic load by base shear load which is manual calculation? (just for more clarification: I can control this by input the scale factor into Eartquake definition in Etabs) I would highly appreciate your answer.

0 Answers  

infosys campus ques... u drive a car,nmb of d car is KA17M8719. it leaves at10:26am frm davanager to bangalor which is264km away at a speed of 95km/hrCar reachs bangalor at 4:18pm. nw tel me wat is d date of birth of drvr

9 Answers   Ernst Young, Infosys,

Define a polyline?

0 Answers  

why 50% more is assumed while calculating dry volume of coarse and fine aggregates in concrete calculations.whether 50% more is correct? How is it decided? whether the same is applicable to cement volume. Also what about cement mortar dr volume? How much more is to be considered for dry volume of mortar.

1 Answers  

how much sand requires for Light weight blocks for 100sqft

1 Answers   Bahria Town, NCC,

Manpower required for de shuttering of conccrete slab

1 Answers   Ameco,

WHAT HAPPEN WHEN USING OF LARGEST POSSIBLE MAXIMUM SIZE AGGREGATE RATHER THAN SMALLER AGGREGATE IN RCC ?

3 Answers  

How much for the BRC lapping in full yield and half yield < and which table to get it ?

0 Answers   Engtex,