In a 11Kv/433Volt Delt-star step down transformer one one
line(Line-B) of HT site is open & earthed on DP structur.
What will be the voltage on LT side R-Y, Y-B,B-R and R-N, Y-
N & B-N?. Please help to understand the problem with
examples.
Arvind , Jaipur.
Transformer diagram mention each parts ?
What are the advantages of the three-phase motor over single phase motor?
Whether capacitor loads can be connected for testing a diesel engine at its full load capacity? Is there any limitation of capacotir load? Which is the best load for testing DG sets?
WHEN TWO ALTERNATORS ARE OPERATING IN PARALLEL, EXPLAIN WHY IT IS OBJECTIONABLE TO OPERATE ONE AT A LEADING POWER FACTOR AND ONE AT THE Lagging power factor?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
what is harmonics?explain in simple words?what is its impact on circuit?
How to test Power Transfomer vector group?
132/66kv sub-station procation ?
what is Thermocouple? Type of its.
why ie corona losses in tranmission line
in general it is observed in power stations, the tertiary winding is used in higher rating Y-Y auto transformer but not in Y-Y power transformer. is the tertiary winding is compulsory then why it is not using in power transformer
What is an automatic controller?