HOW WE KNOW IN PHYSICALLY THE CONTACT SURFACE OF A VACUUM INTERRUPTER IS GOOD OR GOING TO DAMAGE IN A VCB AFTER ABOVE
500 TIMES OPERATED.
No Answer is Posted For this Question
Be the First to Post Answer
how dg's working of 1000kva.
on which power factor synchronous motor run
we know the value of the power factor is 0.8, we know the power factor is not depends upon the load ,then why we cant design the power factor in transformer ?
How can we save theft of wire after finishing of wiring work, plz suggest another answer other than security or supervisor's work?
1.Z transform always lies around ? a) origin b) pole c) zero d) z=1. Multiples Mcqs which is bother me can’t find answers on internet. Some help required with little explanation . Note: this is not homework or related to any test. Thanks
what is meant by LT & HT?
What are hrc fuses and where it is used?
how to check the continuity of a cable with a megger
what is meaning of bus raiser???
which connection is there in a rotor of the motor
2 Answers All Trades Electrical, HAL,
what is power factor?
What is the difference b/w Earthing and Grounding?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)