long form of CT
Answers were Sorted based on User's Feedback
Answer / rajavel
current transformer that ct is measuring current
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / simon peter
A type of transformer use to measure high current into ratio format......
Is This Answer Correct ? | 0 Yes | 0 No |
What will happen if we give AC supply to DC motor?
bit confused - am i correct in thinking that to determine line to line voltage in a star config 110v 3 phase 4 wire distribution system i would use a voltmeter? I have a circuit configured as an unbalanced load, consisting of three incandescent lamps (1x40w, 1x60w, 1x100w - all 110v rated)connected in a star configuration to a 110v 3 phase 4 wire distribution system. I want to find out what types of meters i would use to obtain: a) each line to line voltage b) the line to neutral voltage across each load c) current flowing in each line and load d) current flowing in the neutral conductor e) power supplied to the loads im assuming i would be using ammeters in series along each line and voltmeters in parallel across each line to neutral? Also how could i predict these meter readings before taking them and with which formulae? Any help would be greatly appreciated A.
Please give me a solid reason there are 2 ELCB's If we take Phase from ELCB NO:1 an Netural from ELCB N:2 why ELCB is tripping when we connect the Load?please brief me with detail
Determine the MVA rating of the power transformer given that 110/66 kV,1000 Amps. Folks how can i calculate the MVA rating with this Data??Plz Help........
difference between shunt coil and tripping coil
what is the means of dedicate earthing?
3 ph motor connected in star delta starter. when we start the motor it run in star but when in is going in delta it trips the main incoming supply. why?
how to test generator protection rotor earth fault relay and locked rotor test?
I need tnpsc AE Electrical question papers
2 Answers TNPSC Tamil Nadu Public Service Commission,
In single phase capacitor motor, if the motor rotate reverse direction then how much power will be consumed by the motor and why?
What type of changeover switch needed to run a load of five 1.5 tonn ACs.
What is the maximum percentage voltage drop (vd%)for a motor control center