if i want to make a zero trim for mass flow meter the pipe line should be empty

if i want to make a zero trim for mass flow meter the pipe line should be empty or i need to make it full? i really need the answer pls help me

Question Posted / wansyarafuddin

2 Answers
5432 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

if i want to make a zero trim for mass flow meter the pipe line should be empty or i need to make it..

Answer / satishkumar

If you want to make a zero trim for MASS FLOW METER, the
pipe line filled with liquid or empty pipe line is not a
problem. main important thing is the flow rate must be zero
when ZERO TRIMING of the MASS FLOW METER.

Is This Answer Correct ?

8 Yes

0 No

if i want to make a zero trim for mass flow meter the pipe line should be empty or i need to make it..

Answer / sanjay ajri

Making full gives more correct result.

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

WHY RESISTANCE TEMPERATURE DETECTOR IS AN ACTIVE DEVICE

2 Answers

What is seeback effect?

3 Answers

what is the conductivity sensor output formula and what is the ph sensor output formula?

1 Answers

Draw a complete P&ID of a flow suction tank indicating all control & protection equipment. Indicate all its inlets and outlets. Explain the controls for this system

0 Answers

What is the difference between PLC and DCS?

3 Answers

why the supply frequency used in America is 60Hz while that used in India is 50Hz?,

2 Answers Bosch, Genco,

Why we use 250 ohm resister in series hart communicator?

3 Answers Thermax,

POSSITIVE PULSE IS APPLIED TO AN INVERTER INPUT.THE TIME FROM THE LEADING EDGE OF THE INPUT TO THE LEADING EDGE OF THE OUTPUT IS 10 ns. THE TIME FROM THE TRAILING EDGE OF THE INPUT TO THE TRYLING EDGE OF THE OUTPUT IS 8 ns. WHAT ARE THE VALUES OF tPLH and tPHL?

0 Answers

What is three element in drum level?

0 Answers

what is use single seated and double seated valve?

2 Answers Doha Petroleum Construction DOPET,

I work on a electronic positioner transmitter 4211 at the field.I connect my multimeter in series to get the current output then I calibrate it to 4ma in 0% of position of the valve and 20ma in 100% position of the valve.My problem is in the field I get the correct output current based on my multimeter but in the dcs they only receive 40% in a output 20ma of this positioner.Then I try to simulate in this analog card and they receive the equivalent percent on the value that I simulated.Is ther any possibility to reset the zero and span of this positioner 4211 fisher.And what other possibility I can do to fixed this.This is my email add ( landicho_randy@yahoo.com )

4 Answers

Foe selecting control valve if i have the min,normal & max data of flow rate,inlet pressure& outlet pressure,inlet tem.&density than how can i assure that these data are correct,pl. let me know if therew there is any method to check it.& also how we assure that the Cv we get from this data is suitable for valve for controlling require flow.

3 Answers HPCL,

For more Instrumentation Interview Questions Click Here