why fan consume constant power even when we increase or
decrease its circuit resistance through speed regulator???
Answers were Sorted based on User's Feedback
for fans with old resistive regulators,
total power consumed = heat loss at regulator + fan motor
consumption.
so by setting any speed that much amount of R will introduced
and produce heat loss and remaining will produce motor power.
If electronic regulators are used regulator loss can be
decreased by decreasing speed of fan.
Is This Answer Correct ? | 3 Yes | 0 No |
for fans with old resistive regulators,
total power consumed = heat loss at regulator + fan motor
consumption.
so by setting any speed that much amount of R will introduced
and produce heat loss and remaining will produce motor power.
If electronic regulators are used regulator loss can be
decreased by decreasing speed of fan.
Is This Answer Correct ? | 2 Yes | 0 No |
What is MS-EXCELL?
what is the knee point voltage in current transformer
whye the current increases in the motor when the load on the motor increases
What is the full form of AND,OR and other logic gates
I have a question, I visit 01 site and face a problem, there is 2.5 ton Air Con working, when air con compressor is running at that time rectifier voltages are increasing upto 290-295 v and rectifier is giving main high alarm (rectifier is APC single phase), before starting compressor rectifier voltages was 230v. when air con is going off rectifier voltages are decreasing smoothly at its actual voltages 230v. Load on Genset phases is this: Red-13.5 amp AC (Air Con load), Yellow-1.7 amp AC (BTS lights etc.) and Blew-4 amp AC (telecom system load), Genset phase to phase and neutral to phase voltages are also ok. These are 10 sites having same system and same rectifier APC brand at every site 02 genset are working but the problem is same at all these 10 sites. What will be the reason behind???
What is load boxes ?
In aerodynamic turbines which element is NOT there a.stator b.compressor c. Fuel intake system d.fans
What is the meaning of high reputuring in HRC fuse.?
What is the difference between Neutral And Earth ?
what is over cureent protection
What is the difference between automatic & semi-automatic star-delta starters?
What meant by XLPE cable