why voltage is low at reciving end in summer??

Question Posted / ashokmishra1991

4 Answers
9969 Views
JSW, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

why voltage is low at reciving end in summer??..

Answer / k.prakashchandra

Heavier load and more line drop

Is This Answer Correct ?

6 Yes

0 No

why voltage is low at reciving end in summer??..

Answer / ashokmishra1991

in summer the transmission wire is stretched out due to heat so the length of the wise is increased
that incteases the voltage drop
and voltage will b low at reciving end

Is This Answer Correct ?

14 Yes

10 No

why voltage is low at reciving end in summer??..

Answer / wareagle

Depending where you are, the cooling load go up and thus the
voltage drop is increased.

Is This Answer Correct ?

4 Yes

1 No

why voltage is low at reciving end in summer??..

Answer / kennaniah anthelem

In summer the ambient temperature increase in a certain level, which increases the resistance of the conductor in which causes the increse of voltage at the receiving end, but it will depend on the length of the cable.

Is This Answer Correct ?

5 Yes

6 No

Post New Answer

More Electrical Engineering Interview Questions

what are the difference between PLC and embedded

0 Answers

why making capacity is more than breaking capacity?

14 Answers Essar, Indo Asian, Infinity,

what will happen at secondary side of transformer if i increase voltage at primary side?while V1*I1=V2*I2 will secondary voltage or current increase?

2 Answers

at what base you will tell the direction of rotation of dc motors and generators?

0 Answers

what is mean by harmonics?Type of harmonics?

6 Answers

what is the resultant phase shift in a 3 phase power system including neutral if on or more phases gets grounded or short circuited. kindly explain in detail for the reasons...

1 Answers Enercon,

What is GIS (Gas Insulated Switchgear)

3 Answers Power Grid,

Can the Neutral and Body Earthpits of a transformer conncted together by Earth strips under ground.

4 Answers SanDisk,

A 3PH MOTOR RUNNING IN NORMAL CONDITION AND ITS AMPERE ALSO UNDER ITS FULL LOAD CURRENT,ITS CABLE RATINGS ALSO HIGER THN ITS CAPACITY,BUT ITS CABLE GETTING ABNORMAL HEAT(NOT TOO HOT)WHY ITS GETTING HOT LIK THIS

2 Answers

what kvrah y we need to take the readind of that

0 Answers

What is the Diff. btw Fire Alarm System & VESDA System??????

1 Answers Emerson,

1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?

0 Answers

For more Electrical Engineering Interview Questions Click Here