Answer / srilakshmi

Use the following formula to estimate the amount of wall paint you need. Double the result if the walls require two coats.
1. Add together the length of each wall.
14 + 20 + 14 + 20 = 68 feet

2. Multiply the sum by the wall height, to find the total wall area.
68 × 8 = 544 square feet

3. Subtract 20 square feet for each door (20 × 2 = 40) and 15 square feet for each window (15 × 2 = 30) to find the actual amount of wall area you're painting.
544 – 70 = 474 square feet

4. Divide this figure by the paint coverage (350 square feet per gallon), and the result is the number of gallons to purchase.
474 ÷ 350 = 1.4

For this example, you want to buy 1 gallon and 2 quarts of paint for a single coat.

Answer / asha

The paint coverage area varies based on the type of paint.Using the manufacturer catalog we can find out the coverage area.Area calculation is correct. but coverage area is wrong.

Why there is no use of sea water in producing electricity

20 Answers   Infosys,

---

how many cubic ft. for 50 kg ( 1 bag ) cement?

20 Answers   ATS,

---

I found a crack on a slab in my resi.bldg.There must be a leakage.what shall i do for preventing the leakage?

3 Answers   L&T,

---

Deshuttering time for slab 6.15 meter

2 Answers  

---

In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.

0 Answers  

---

Method for Calculating the WEIGHT OF ANGLE ?

3 Answers  

---

How good are the Weinerberger Porotherm bricks that are being used in construction in Chennai, India. Its being used in non load bearing walls and has a compressive strength greater that 35 kg/cm^2 and a density of approx.694 - 783 kg/m3.

0 Answers  

---

what are the forces acting on gantry girder

1 Answers   CTS,

---

plz answer the questions, How do you check the quality of foundation? and What is the key performance area in quantity survey?

1 Answers  

---

what will be the cost of thickness of 125mmor rcc measurement of 52x33.75 feet

0 Answers  

---

what is development length,where it is used and why it is used?

1 Answers  

---

waht is the angle of reposae

2 Answers  

---