Suppose a column is of 1mx1m dimension adn load is of barely 1 ton(no moment), will u provide the total minimum steel reinforcement, if not what will u do..?

1 Answers   Engineers India Limited,

---

what r remedies taken for foundation in black cotton soils..??

1 Answers  

---

standared weighs for differnt grade of concrete

10 Answers   Reliance,

---

why shear is not considered in limit state of serviceability??

1 Answers  

---

how to determine pile length and diameter of pile is there any thumb rule?

2 Answers   Al Habib,

---

A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.

0 Answers  

---

undistributed samples are obtained by

0 Answers  

---

how calucate cement sand ratio for plstering

0 Answers   DMRC,

---

what is a moment connection and shear connection ? where it provided ? why it provided ?

1 Answers  

---

What is the quantity of cement, sand, and gravel to be used in M20 grade of concrete for 1000 x 1000 x 1000 mm of sand (for cement please mention in kilos, and for sand and gravel please mention it in CFT)

7 Answers  

---

which method is used in semi-rigid connection design??

0 Answers   L&T,

---

  what is purpose of PCC  Below Footing ?

5 Answers   Vistacore,

---