Why we use a H.T. Fuse from a thick wire, on other side we use
high rating of cables?
& Why we use less Sq. mm Cable on H.T. side , on other side we use Large Sq. mm cable?
Answer / anurag pattanayak
what kind of question is this?
anyway...with watever i could make out of your question..
HT = very low current..So fuse wire rating should be low..hence Sqmm is low...
and vice versa for LT
| Is This Answer Correct ? | 7 Yes | 0 No |
What is advantages of ungrounded neutral?
do you know measure the earth resistance?explain
We have 420volts, Diesel gen-sets each 750kva 4nos. we are operating with bus bar duct having 10x150mm for each face 4nos. our question is what is the minimum gap required between each face? is there any satutory regulations?
why the voltage level in transmission line are in multiple of 11kV, 22kV, 33 kV etc..( i.e., 220 V )?
state types of reflectors in illumination engg. ???????
what is the use of interposed & reverse voltage transformer
what is difference b/w HT & LT and the range of HT & LT ?
if we supply to secondary winding how transformer work?
what is intermediate switch
In hydel power plants, L.A's, S.C's are placed inside the control panel boards. what is the purpose? [already the total body was earthed to ground.]
What are the difference between off-load tap changer and on-load tap changer in transformer?
Why the airgap of an induction motor is less compared to that of a synchronous machine?
4 Answers MGVCL, RRB, WebTech,
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)