can any one explain in which term we are flow flow is it
volumetric r is it mass? and y
No Answer is Posted For this Question
Be the First to Post Answer
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
Can anybody tell me which type of question are asked in the interview for the FORMULATION(Pharma) as a instrumentation engineer, & question in building managment system.
0 Answers Reddy Labs, ScienceWay,
what is the difference between two wire transmitter and 4- wire transmitter
What is the GK Value in Flowmeter?
What is the main difference between the terms instrumentation and Automation?
hydrogen purity meter calibrating and commissioning procedure can be explained?
please someone tell me what is function of vibration sencer and how many types and how to control viberation.please. my id is jimmykhan077@gmail.com
Pls can anybody tell me how much memory plc's has?in byte or in Kb
In RS 500 SLC 5/03 input change one module card to another card, plz. give steps clearly.
INtools Trainining
1 Answers Monarch Techno Engineering Solutions,
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
How can we say that accuracy of measurement increases by using 3 or 4 wire RTD? because for example: If resistance of RTD element is say r ohms and Resistance of the cable from transmitter to RTD is R ohms And if 4 wire RTD is used, ____._____________________ R ohms | |_____._____________________ R ohms / \ / r ohms \ \ | |______.__________________ R Ohms | |_______._________________ R ohms Then the actual resistance measured will be: Total = r + R/2 + R/2 = r +R Ohms Note: r+R instead of r ohms. hence error