what is the diffrence bitween hypo eutectoid and hyper eutectoid steels?
Answers were Sorted based on User's Feedback
Answer / kmallick7@gmail.com
Hypoeutectoid steel contains 0.8% carbon whereas later contains more than 0.8% carbon.Former structure is a combination of ferite & perlite whereas Hypereutectoid steel is a combination of perlite & cementite.
Is This Answer Correct ? | 33 Yes | 14 No |
Answer / rohitmathanker87
hypo eutectoid steels are those which is contain less than o.9% carbon where hypereutectoid steels contain more than 0.9% steels.
Is This Answer Correct ? | 44 Yes | 29 No |
Answer / lee parker cordochorea
Annealed hypoeutectoid steels have a microstructure of
pearlite and ferrite. Annealed hypereutectoid steels have a
microstructure of pearlite and carbides. Annealed eutectoid
steels have a microstructure of pearlite exclusively.
The percentage of carbon in a eutectoid steel depends on
which additional alloying elements are present and in what
quantities. For a more complete explanation, read
"Principles of Heat Treatment of Steel" by George Krauss.
Is This Answer Correct ? | 9 Yes | 1 No |
Answer / amare mulugeta
Hypo-eutectoid steel has less than 0,8% of C in its composition. It is composed by pearlite and α-ferrite. Hyper-eutectoid steel has between 0.8% and 2% of C
Is This Answer Correct ? | 7 Yes | 1 No |
Answer / ishmael akwei
Hypoeutectoid steel contain high carbon 0.83% and hypereutectoid steel contain low carbon 2.00%
Is This Answer Correct ? | 2 Yes | 1 No |
how can you calculate angle of bite practically???
what is ultrasonic flaw decdector?
What do you treat in high alkalinity of boiler water? What is a feed water pump? What is a Booster pump?
WHAT IS THE DIFFERENCE BETWEEN A 500MW AND A 650 MW BOILER ?
what is the trignometry of lifting tools using the wire rope ? any formula for trignometry ?
What will be the cause of scavenging fire?
What are the different types of mechanism to engage primary moving engine and transmission (in other words how many different types of clutches are there)?
How differential gear boxex work?
sir ,i applied rrb chennai for the post of junier engineer please sent model question papper with solved data to my mail id.aravindaptc@yahoo.co.in
hi friends kumar here if anybody of u have " INDRAPRASTHA GAS LIMITED" placement papers than plz send it to me i need it urgently..ok mail id is ashish_me2007@yahoo.co.in
In d thermal power plant why D/A placed on height.
Steering handle (round dial) of motor vehicles (CAR,BUS,LORRY) wiil be designing with two cross supports without 180 degree straightness( it will be little bit cross). Why?