why spark is produced in mosquito bat?and what are the ways
to reduce it?
Answers were Sorted based on User's Feedback
when the switch made ON in bat, a low current will flowing
through the entire bat.. the current is DC., hence when a
mosquito touches the bat, it means it interrupting the circuit
then it get short circuited, the current will flow through the
body of mosquito.. so the mosquito gets burning and hence the
spark..
Is This Answer Correct ? | 8 Yes | 2 No |
Answer / ravi pradhan
The net structure is primarily made up of three layers of metal mesh and is rather a complicated assembly.
The inner central layer is actually the "hot" mesh and is terminated as a high voltage source from the circuit enclosed in the lower handle area. The outer two layers are simply connected with the negative of the battery and constitute the ground for a return path to the central “hot” mesh line.
However since the inner layer and the outer layers are separated from each other at a reasonable distance, the high voltage from the central mesh in unable to arc-off through the outer layers, but when a “victim” (a mosquito in this case) flies into this trap and bridges itself in between the layers, its body creates a low resistance path in between the layers of the mesh so that the high voltage is now able to arc through the body of the mosquito which is instantly electrocuted.
The circuit supplying the required high voltages to the above mesh in fact becomes the heart of the whole procedure
The boosted voltage ranging several thousand volts gets stored inside an output AC capacitor across the output HOT ends which are finally terminated to the bat meshes and becomes ready to “shoot.”
The moment a mosquito or any bug comes in contact with the meshes, the stored high voltage in the capacitor discharges violently through the body of the entangled bug creating a big spark and electrocuting it instantly.
Is This Answer Correct ? | 3 Yes | 2 No |
What are the applications that use Solid State Drives in your home?
During he starting up of the motor, the upstream's MCCB (350A) always trips due to the UVT relay activated. Can Star-delta starter use for a 20kW Motor (For a powder mixer machine) cause voltage-dip in the supply line voltage? If so, what are the recommended solution to eliminate/reduce the transient voltage dip in the line voltage?
after how many spot we must chang secondry cable in portable spot welding gun?
What is the actual meaning of thermal power efficiency ?
What happen when increese more than 50HZ fequincy.
when the supply of MSEB is cut off & all the load of the industry is driven on generator at that time the capacitor which is connected in industry for power factor control is switched off why?
what is the interrelation between voltage current torgue speed and magnetic flux in case of different types of electric motors
neutral earth resistance testing is it possible for transformer while in load condition
why ohms law does not obey semi-conducters?
what is iron loss?
what is meant by bus bar and outgoing/incoming breaker in an electrical/electronic circuit
HOW MUCH MAXIMUM CURRENT TAKEN BY NEAUTRAL IN 125 KVA DG SET