Answer / xyz

actually thickness is just for distinguishing it from
others and it is more in length than other pins as to
connect earth first to circuits.

Answer / mandeepsingh987

Hi..
Actually you are all right, Earth Pin is Thicker as well as
the longest of all among them.
Its the longest because of the reason that every time you
put the plug in the wall mount, if there is current leakage
then it would firstly be earthened and thus saving your life.

Regards,
Mandeep

Answer / bala

Actually the earthpin size is high and thickness is also large to pass more leakage currrent and not for load current.Load current normally returns via neutral.and one more thing is earth is taken care for high current rating devices whose current rating is above 5A.

Answer / thavam

any shot-circuit condition and current leakage for provide
in human and electrical equipment. this purpose provided
earth pin is thicker than other pins

Answer / avnish

you are absolutely correct that it is for redusing the
resistance so that current can pass,As we all know that
current follows min. resistance path. As far your next
question if we keep earth wire thick as pin of socket than
it will be very costly comparision to previous one .So as
this will considered as cost point of view....thanx

In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.

0 Answers  

how one can know the charging time, discharging time of a 12 VDC battery ? If i have a battery of 12 VDC , 4.0 AH , how long will it take to charge from a charger (power supply) of input 220 V , Output 15 V and output current of 3000 mA and how long will it take to discharge whether using or not ? How much backup will it give ?

1 Answers   ONGC,

How to setting the volume of RTCC panel AVR (11kv) controller

0 Answers   CNF Automotive India,

Tell me about Tesla.

1 Answers   Tata Power,

List the power rating of any 5 important electrical appliances used in houses.

0 Answers  

how to measure earth resistance of a substation

0 Answers  

ups battery design formula

0 Answers   Amara Raja,

Is earthing done for AC or DC or both?

6 Answers  

Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.

0 Answers   Pride Hotels,

how could we know the size of cable by physical view?

0 Answers   Havells, United Engineering,

what is the diffrence between preventive maintinance corrective maintinance?

7 Answers   Siemens,

What are the three constants associated with a steady state error?

0 Answers