What is the function of semicon in 33kv ht cable ?
Answers were Sorted based on User's Feedback
Answer / k.prakashchandra
It is used to influence the electric field within the
insulation layer.The semicon layer has to removed at the
termination at least 6-9 inches below the lugs ,as
otherwise there will be short circuit along this layer.As
this layer is not doped, you have to treat it as a conductor.
Is This Answer Correct ? | 10 Yes | 4 No |
Answer / paramesha r l
Purpose of semiconducting layer is to maintain uniform distribution of Poynting vector i.e., P=ExH in insulator or otherwise power P=EXH densely concentrated at insulation point where two phase are comes in contact.
what Semiconducting layer does is equipotential over outer surface of insulating medium as it is like a free space.
Semiconducting layer needed to remove at termination i.e, 35 to 50 cm from lugs point.
If semiconducting layer not removed at termination leakage current flows between conductor to semiconducting which is hardly a distance of 5mm at eventually it fails.
Is This Answer Correct ? | 0 Yes | 0 No |
The purpose of Semi conducting tape is only to transmit the
heat from insulation to cu. tape over it. this heat is
produced in Core due to flow of current. Further, to
TERMINATE THE CABLES, ALL CONDUCTING AND SEMICONDUCTING TAPE
IS REMOVED FROM INSULATION AS current in cable can also come
into insulation and it may be damage the cable, dangerous to
persons working.
Is This Answer Correct ? | 3 Yes | 9 No |
Answer / marlo
Usually HV cable has a semi conducting, one purpose it to protect your connected load in severe damage and the system as well. In the case of unexpected faults along with this cable,any small leakage current detected will trip its protection.
Is This Answer Correct ? | 2 Yes | 10 No |
what is meant by trip circuit supervision & directional or non directional over current ?
if AVR fails in D.G set, what will be the effect?
Why the arms of delta in a delta-wye power transmission system are kept constant??
IAM WORKING IN THERMAL POWER PLANT AS A TRAINEE.. I WANT TO IMPROVE MY CARRIER., IF ANYBODY KNOWS ANY COURSES., ANY TESTS, ANY BOOKS ,, ANYTHING PLS HELP ME..
What is step signal?
what is difference b/w bus duct & bus bar.
What is mean by PID controller? And what is its Long form?
what is the earthing condition between earth & phase.
For 132 KV line, PT or CVT which is prefered for measuring & protection? is there any IS or IEE standard available?
How we Use DC Power in Transformers? is it possible ?
How to select transmission line type (i.e. 11kv or 33kv) for new established industries
how and where does star and delta connection is used ?