Answer / jaikumar

IN REFRIGATION WE TAKE
1 TR = 400 CFM (cubic feet per minutec)

As we all are aware of the following formula which is;

flow = area * velocity
i.e.
Q=A*V
( where Q= Air quntity in cubic feet per minute,V =
velocity in feet per minute,A = Area in square feet)

the value of velocity is depend on the different type of
air conditioning application
generaly for offices 1200 FPM
so put this two values of velocity and CFM in above foremula
we get DUCT AREA in sq.ft. then take the height or width as
per site.

now (Area /height = width)

that is the duct size.

I have applied the post Junior Engineer-iii(c&w)in R.R.B Guwahati recently . what type of question i have to practice and which book ?. can i get any model question paper?

6 Answers   RRB,

---

what is the use of feed water treatment in boiler?

2 Answers  

---

What causes steam turbine governer hunting?

7 Answers   Bhel,

---

define hookes law?

2 Answers   HAL, Jindal,

---

How is a submarine able to submerge and surface?

0 Answers  

---

---

After any cause of repaired how i start the engine by slow speed 800 to 900 rpm electronic control moudle engine [cummins]

0 Answers   Cummins,

---

Out of constant pressure and constant volume lines on ts diagram which line has higher slope ? And whether slope is constant or variable ?

0 Answers  

---

what is the surge tank ?in the pump station.(surge tank by pipe connected to discharge line)

1 Answers  

---

what is the thermal efficiency of SI engine with range value?

2 Answers   Sail,

---

Which reactor uses heavy water as moderator ?

0 Answers  

---

In a reaction turbine,where the pressure drop will be in fixed blade or moving blade?

3 Answers  

---

Did elevation affect weight?

0 Answers  

---