Golgappa.net | Golgappa.org | BagIndia.net | BodyIndia.Com | CabIndia.net | CarsBikes.net | CarsBikes.org | CashIndia.net | ConsumerIndia.net | CookingIndia.net | DataIndia.net | DealIndia.net | EmailIndia.net | FirstTablet.com | FirstTourist.com | ForsaleIndia.net | IndiaBody.Com | IndiaCab.net | IndiaCash.net | IndiaModel.net | KidForum.net | OfficeIndia.net | PaysIndia.com | RestaurantIndia.net | RestaurantsIndia.net | SaleForum.net | SellForum.net | SoldIndia.com | StarIndia.net | TomatoCab.com | TomatoCabs.com | TownIndia.com
Interested to Buy Any Domain ? << Click Here >> for more details...


How much calorific value of heat is needed to heat 00c of


No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Mechanical Engineering Interview Questions

how many type of engine?

7 Answers   L&T, SSB,


What are the types of sensors?

0 Answers  


an engine operates between temp of 900k and t2 and another engine operates between t2 and 400k. for both engines to do equal work what shuld be the value of t2? a)650 b)600 c)625 d)700 e)750. with explaination.

6 Answers   General Motors GM,


Is there a lower limit to the gland surface finish for static O-rings, gaseous system? surface finish table lists 0.41-0.81 micro-meters for static gaseous systems. What is the drawback of using a smoother surface finish lower than 0.41?

0 Answers  


what is the responsibility of production department ?

1 Answers  


Difference be betwin Fe-500 as per IS 226-1975 & IS 2062-2006

0 Answers  


How to convert GSS duct volume in KG for all guages

0 Answers  


Please provide me Hindustan Pretroleum Question Paper with Answers

0 Answers   HAL, IOCL,


Give the safety precaution when working in a high place.

0 Answers   RRB,


What is net refrigerating effect of the refrigerant?

0 Answers  


what is critical temprature discuss that is any pressure greater than critical pressure is valid for boiler design.....2 in what cycle steam power plant is based draw h-s diagram.different process to make gear what is tooth profile what is generatic and directric and many more as i m doing mtech thats why interview was of 30 minute...........

0 Answers   DVC,


how to calculate cg of transformer

0 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5086)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4456)
  • Electrical Engineering Interview Questions Electrical Engineering (16639)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)