What causes crankcase explosion?
No Answer is Posted For this Question
Be the First to Post Answer
Draw L.O. system in diesel engine?
Define buckling factor?
At 50 Centigrade (Diesel oil) what is its cast?
25 questions in 25 minutes were asked by L&T corein mechanical engg test on 28 nov 2011 are as follows:- L&t mechanical consists of 1> airfuel ratio 2> mollier chart for flow rate 3>homogeneous or hetreogeneous mixture 4>sublimation curve 5>effect on room temperature when fridge is opened 6>cop of refrigerator 7> punching and piercing uses shear or not 8>method not used for tapering 9>forming method not used for productn 10>numerical regardng no.of cuts 11>flow of chip is controlled by which parameters 12> property important for impact loading 13>stifness of spring when it is cut into 2 pieces 14> device reqd for energy fluctuation 15> property on which rivet is selected 16>crowning to prevent flat belt pulley errors like undercut 17>cavitation occurs at which stage 18>qstn regardng inventory control 19>for ship vessel industry what sort of plantlayout reqd 20>value engg definition 21> qstn on how the extnsn occurs for uniform loading 22> qstn regardng stress actng on the shaft23>maximum value of mohr's circle diameter 24>qstn regardng meshing of teeth 25>qstn on helical gear reqrd better read G.K.PUBLISHERS GATE PAPERS ESPECIALLY FROM 1993 to 2003 ESPECIALLY THEORY QUESTIONS RATHER THAN NUMERICAL QUESTIONS
wap to insert an element in array at a particular location
we have read that when the piston goes up and down then the engine works i.e. the suction,compression etc etc. then what happens in the case of big vehicles, which start at stable condition, i.e. how does their piston moves when they are at rest. how suction,compression etc
If mft not act when spark failure 3 time what problem will happen in boiler side
What is the difference between air conditioning and refrigeration?
examples for newtonian and non newtonian fluid
14 Answers Applied Materials, NTPC, Wipro,
How much water pressure will come from gravity feed tank, which is 10 metres high?
min work in a compresor is possible when the value of adiabatic index n is equal to a).75 b)1 c)1.27 d)1.35 e)2 what is adiabatic index.
what is the minimum height at which safety belts are mandatory as per safety rules?