difference between 1st angle and 3rd angle projection
No Answer is Posted For this Question
Be the First to Post Answer
What is the tolerance allowable for ISMC 150(c-channel) as per IS 2062? I want the min and max dimension allowable in raw material?
How do you repair a hydraulic jack?
I got i20 for university of bridgeport,university of new heaven and eastern michigan university.Please tell me visa success rate for these universities.And I want to go to Connecticut.At that place two universities are avaliable one is new heaven and the another one is bridgeport.Which is the best? Please give reply as early as possible.
Why U want 2 join TCS?
1.What is the difference between safety valve and relief valve?
what is the ejection system in mould making?
What are the characteristics of Freon 12?
If we heat the rod what will happen,draw stress & strain curve before after heating ?
1)Why Bearing used in Motor and pumps. 2) Why Mechanical seal used in Pumps.
16 Answers Biocon, Exxon Mobil,
What do u mean about Gear Coupling Number like 101,102,103.....110,112....and how u will get proper Number of Gear Coupling.,Explain it.
why we use air blower instead of air compressor in STP Plant.?
Is it ABS AH 36 material equivalent to IS 2062 Gr B material.