Answer / soumyajeet

A Interrupt is a condition that causes the microprocessor
to work on a different task and then later on return to its
previous task. It is of two types
1.Internal or software Interrupt
2.External or hardware Interrupt

Answer / rahnaash

interrupt is an asynchronous signal indicating need of
attention or need of change in execution

it is coming from outside the processor

Answer / deeptirekha biswal

to break the sequence of operation. while the cpu is
executing a program, an 'interrupt' breaks the normal
sequence of execution of instructions & diverts into some
other program called Interrupt Service Routine(ISR).After
executing ISR the control is transfered back again to the
main program which was being executed at the time of
interruption.

Answer / muzz

interrupt is an situation where there arises the need for the master to look in an attention seeking event.

Answer / madhu.k

when an higher priority task is in queue,the process of low priority task will be interrupted by enabling the IF flag to 1 and high priority task is executed first this is done with the help of interrupt flag

Answer / faizan

interrupt is a device which is used for.............
((think about it)) hahahaha

Answer / ghilli

interrupt is....excuse me!!..am i interrupting??...:-P

explain osi model???

1 Answers   Nokia Solutions and Networks,

What are the main components of AMF panel. Is it required to use ATS in LT panel if DG is used as stand by supply? Please send any single line diagram showing AMF & LT panel etc., if possible please send to sreenu_207 @ yahoo.co.in

0 Answers   HAL,

What is meant by phase reversal?

0 Answers  

why we use asynchronous communication in microcontroller.but synchronous is high speed communication than asynchronous.

0 Answers   Finolex,

what is protocol.what is tcp/ip,http/ftp protocol

3 Answers  

i am prepared to sectionengineer exam so which books are referd for that exam pls tell me

0 Answers  

What do mean by mnemonics in microprocessors? Give few examples.

9 Answers   NTPC,

What is astigmatism control?

0 Answers  

Describe transducer ei pickups in instrumentation and control engineering?

0 Answers  

Dear concern Plz provide me the solved papers of Railway section engineer in signal...

0 Answers  

What are the drawbacks of walsh codes?

0 Answers  

Most computers wont use floating point arithmetic .why

2 Answers