Answer / mukund

it depend which mccb you have most hase thermal and
megnetic ttrip setting for thermal you cand set may 110 to
120 % of full load amp. and megnetic 3 to 10 time of FLA go
with less time suppose 3 time if mccb trip when load
connected increase little higher

ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]

0 Answers  

---

What is the difference between Type test and Routine test?

10 Answers  

---

physical identification of HT & LT panel

0 Answers   Schneider,

---

what is the difference between PLC and embedded system

3 Answers  

---

plz explain the snubber circuit unit

1 Answers  

---

What are the possible causes if load is not same on all the three phases

4 Answers  

---

how to select the mpcbs and contactor for 3 phase 30 hp star delta motors.for plc control.and tell me the calaculation for future use.

0 Answers  

---

Period of infinite continuous fourier series a. N b. N+M c.infinite

1 Answers  

---

Please define ampere?

0 Answers  

---

WHAT IS NORMAL VECTOR GROUP USED FOR DESIGNING OF TRANSFORMERS??

0 Answers  

---

Resistance of a conductor in a close electrical ckt is practically zero why?

1 Answers  

---

In short transmission line,why does the receiving end voltage is less than sending end voltage?

4 Answers  

---