what is formula in determining the size of Circuit Breaker for transformer wit

what is formula in determining the size of Circuit Breaker
for transformer with the following specifications. 7 units
of 1600 volts (primary) and 400 volts (secondary). Both
Primary and Secondary will have a circuit breaker which is
SF6. What should be the Switchgear Main Breaker Size anf
the sizes of each brances Circuit Breaker for Primary.

Question Posted / dalton

1 Answers
4112 Views
ABB, I also Faced
E-Mail Answers

what is formula in determining the size of Circuit Breaker for transformer with the following spec..

Answer / k.prakashchandra

What is the expected max load?

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

I've descovered that when the earth wire in a domestic electrical installation is not connected back to the board (ground) a voltage of between 9-24v is is found to be present in the earth wire. When connected at the board there is no voltage - is this normal and why does it happen?

3 Answers

Why are use 22 kv 3ph supply ?

1 Answers IOCL,

which protection function should measure RMS value of current&DFT value of current?

0 Answers

How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?

0 Answers NA,

A current of 2A flows for 10 hour through a 100 ohm resistor. The energy consumed by the resistor is:(a) 0.5 kWh(b) 4 kWh(c) 2 kWh(d) 0.02 kWh

3 Answers

If we are importing real power & exporting reactive power then what will be the effect on our system

3 Answers

What is the simplest formula to calculate the rotor diameter of a synchronous generator?

0 Answers PEI,

how generator generates electricity?

1 Answers Suzlon,

what is the mechanical safety of DG ?

0 Answers

a 3 phase motor was running with delta connected, suddenly one phase winding got burnt off, what will be the effect ?

8 Answers Bhel, RRB, SR,

what is difference between mccb,mcb,elcb,pccb

7 Answers

Why charcoal and salt add in earthing pit.

6 Answers Garware, NTPC, Sterling Wilson,

For more Electrical Engineering Interview Questions Click Here