In power plant to measure vibration of a turbine we install
sensors. Before install this sensor we have to set gap
voltage. What is meant by gap voltage and its use?
No Answer is Posted For this Question
Be the First to Post Answer
What is live zero and dead zero
Square root calculation for dp flow transmitter?
why we set -10 volt in vibration sensor output,why not +10 volt
generally transmitter power supply having some range(12v to 35v) but the out put(4-20 mA) must same for given input.If we vary the power supply voltage then output mA also to be change according to V=IR. Is there any voltage regulator in the transmitter ?
How many input(Analog and digital) and outputs(Analog and digital) are there in DELTA v DCS Version 7.0?
What is the difference between a double acting and single acting positioner? what type of valves use single acting positioners?
1 Answers AquaTech, NamPower, Samson Resources,
in a electronic controller why we are using 250 ohm resistance in input signal?is i/p is necessary in control valve when we are using electronic controller give details?
What is the use instrument barriers? Can you give me review materials about this?
On drum level, why we are using air to close Control valve?
what is difference between 1/2"NPT & M20 x 1.5 cable gland?
1.Give example of analog and digital signal 2. What is yhe advantage of 8086 than 8085
5 Answers Bhel, College School Exams Tests, Profitec,
How is plc installing done