Answer / sreedarsh

VfD. Variable frequency drives are used to control the speed of induction motors which is the driving force for 90% of the pumps in Industrial application. simply saying the are used to control the flow as per the requirements. the flow may be water, air or gas. A motor running at 50% of full speed capacity has a motor torque of 25% of full speed. In
addition, electricity required to operate the motor at 50% of full speed is 12.5% of the amount
of electricity required if the motor was running at 100% full speed capacity. Thus, reducing
motor speed can significantly reduce the electrical energy consumptio

Why the pointer of earthing of 3 pin top is made thick and long compared to the phase and neutral pin ?

3 Answers   Sanima Hydro Power,

---

what will happen if ac motor given dc supply?

1 Answers  

---

dg earth connect only in the amf panel or not why

0 Answers  

---

Can run 11KV(5MW) slip ring motor by appling 415V? if Yes and what are the processors?

2 Answers  

---

HOW DG WORKS ?

3 Answers  

---

what is the difference between MCB & MCCB

3 Answers  

---

New istallation how many eathing have one transformer? Names of earthing connect places?

10 Answers  

---

deisel generators all elcetical calculation formule's

1 Answers  

---

How one can check the faulty capacitor, diode when connected in the circuit ? and when you can not take them out ?

4 Answers  

---

tell me the operation of ELCB. How it detects a fault?

4 Answers  

---

What will happen if power transformer designed for 50 Hz is connected to 500 Hz of the same voltage , and vice versa ?

1 Answers  

---

what is a breaker fail relay

0 Answers   Eskom,

---