in a dc motor we supply current only to the armature conductors,from where is t

in a dc motor we supply current only to the armature
conductors,from where is the field winding gets excited then??

Question Posted / funti111

3 Answers
4789 Views
RRB, Siemens, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

in a dc motor we supply current only to the armature conductors,from where is the field winding get..

o helo bewkoof
y are u confusing me.
dear there are two types of dc motors
1. self excited
2. seperately excited

in self excited the armature and field are fed from single
supply
while in seperately excited motors two different supplies
are used

Is This Answer Correct ?

31 Yes

2 No

in a dc motor we supply current only to the armature conductors,from where is the field winding get..

Answer / abhsiehk

in d.c. motor both the armature & field are supplied by
d.c. supply

Is This Answer Correct ?

5 Yes

1 No

in a dc motor we supply current only to the armature conductors,from where is the field winding get..

Answer / k.prakashchandra

Let us not forget about permanent magnet motors which are
usually very small

Is This Answer Correct ?

2 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

why a tester wont shock while testing the power in house

0 Answers Tessolve,

An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor frequency at maximum torque point is A 3.33% B 4.44% C 5.55% D 6.66%

1 Answers

In electrostatic precipitator why positive terminal of tranformer rectifier unit is grounded?

2 Answers

What is the diference between increased saety motors and non sparking motors?

1 Answers

how CBCT works?

1 Answers

What is function of inverter? and who it's operate & what are controlling devices are used?

2 Answers Carrier, Dalkia,

Write a note on materials used as a fuse element.

0 Answers Bhel,

Why we use the D-curve MCBs in critical power distrubution.

4 Answers Sodexo,

We wish to test 60 Hz systems from a 50 Hz supply. To acheive frequency conversion, we use a VFD. The VFD powers 40 kVA transformer, which has motor and non-motor loads on it. Will the transformer work?

2 Answers Suzlon,

in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?

0 Answers

what happens when we apply dc to a transformer

7 Answers Siemens,

how we can calculate which capacity capacitor bank we have to add for improve pf?

3 Answers Consultancy, JM Huber, Torrent Power,

For more Electrical Engineering Interview Questions Click Here