Why the ceiling fan has three blades, why not two,four or
five?
Answers were Sorted based on User's Feedback
Answer / rishi barnawal
Best compromise is achieved by choosing 3 blades between equilibrium, cost and weight of fan.
Is This Answer Correct ? | 8 Yes | 0 No |
Answer / nba
The torque required to run more than three blade fan goes on
increasing as no. of blades increase. Thus, Three Blade Fan
is ideal..
Is This Answer Correct ? | 13 Yes | 6 No |
Answer / himanshu chudasama
Its an simlpe as per angle placement as well as balacing
formula angle should be 120 degree minium and if we
consider 360 for round air cathcment area for fan 360
divide by 120 so we will get 3 blades minimum kept for fan
for the balanced efficient use of it.
Is This Answer Correct ? | 21 Yes | 22 No |
Answer / ramesh
because of the equlibrium balancing capability of the 120
degree apart placing of the wings
Is This Answer Correct ? | 5 Yes | 17 No |
How can we check ELCB trip current sensitivity How can we check earth resistance value
When we giving the 3 phase supply to ups system how to coming netural?
0 Answers Juniper Networks, Tata Motors,
WHAT IS MEANING OF Gg & Gg IN hrc FUSE
what are the shades for mimic diagram i.e for 3.3kv,6.6kv,11kv,22kv and 33kv? which is the IS for mimic diagram?
Please define ohm’s law for a.c (alternating current)?
why we remove capacitor connection in 3 ph Induction Motor while taking noload test.
Hi I'm doing my MBA(3rd semester).I applied for the post of ET conducted by BHEL the last year.I cleared the written and lost in personal interview.Again I wrote the exam this time and cleared the written n yet to take the personal interview.Shall I disclose in the interview about my studies.What shall i say if they ask about my change from studies to job
give me list of material for wiring of 20hp motor?
How to calculate total harmonic distortion level(THD) in VFD? and how can we reduce harmonics?
DG use Rating KVA why
the parts of transformers ?
1 Answers Bhel, Facility management,
Why we are putting off the APFC(automatic power factor control) panel while the generator is running?