generally in LT and MV motors we are using 3.5Coresx16,25,35,50 etc cable for

generally in LT and MV motors we are using
3.5Coresx16,25,35,50 etc cable for supply.although motors
is earthed at two point and having all protection.then why
we are using that 1/2 core for earthing the motors.while in
HT cable we are using only 3core cable for motor
supply.generally lt and mv motors are delta connected and
ht motors having star connection.whethere it is having any
relation with winding connection( star or delta).all motors
i am talking about are dol only.can anybody solve my
confusion.thanks...

Question Posted / paresh

0 Answers
1535 Views
I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Electrical Engineering Interview Questions

what is the difference between ACTIVE POWER and REACTIVE POWER.I WANT CLEAR ANSEWER.

8 Answers

DG drop how much freqency at 100% load?

3 Answers

1,Building containing 25 flats how much Amp 3 pole MCCB are required? 2, For the safey of each flat how many Amp RCCB can install -loaded with A/C

1 Answers L&T,

what is the operating time for LBB and how does the LBB relay realise whether cb is opened or not?

0 Answers

what is meant by HT&LT?

5 Answers

why we used servo motor insted of inducation motor?

1 Answers

Define average demand?

0 Answers

I have a question, I visit 01 site and face a problem, there is 2.5 ton Air Con working, when air con compressor is running at that time rectifier voltages are increasing upto 290-295 v and rectifier is giving main high alarm (rectifier is APC single phase, before starting compressor rectifier voltages was 230v. when air con is going off rectifier voltages are decreasing smoothly at its actual voltages 230v. Load on Genset phases is this: Red-13.5 amp AC (Air Con load), Yellow-1.7 amp AC (BTS lights etc.) and Blew-4 amp AC (telecom system load), Genset phase to phase and neutral to phase voltages are also ok. These are 10 sites having same system and same rectifier APC brand at every site 02 genset are working but the problem is same at all these 10 sites. What will be the reason behind???

1 Answers

What is the operational principle of direct current current transformer and direct current potential transformer?if possible plz reply with ckt. diagram.

1 Answers

Can anyone send details regarding motor protection relays ? their manuals please ?

1 Answers

what happen if turbine trip ,g.c.b not open and excitation on condition?

1 Answers

Why soda is added with water in Lrs of Sliipring motor…to Increase or decrease resistance of water?

1 Answers

For more Electrical Engineering Interview Questions Click Here