Why do we use 500ppb sucrose and 500ppb 1,4 benzoquinone in
TOC calibration?
Answers were Sorted based on User's Feedback
Answer / vishal shah
In TOC calibration 1,4 Benzoquinone used because 1,4
Benzoquinone is tufest to oxidized and sucrose is easly
oxidized so cover upper and lower range for calibration.
Is This Answer Correct ? | 53 Yes | 0 No |
Answer / dev rawat
In Toc Analyzer Calibration (System suitability) we are preparing Standard sucrose of 500PPb and Benzoquinone Preparing of 500ppb . Sucrose is easy to oxidized and p- Benzoquinone is hard to decompose(oxidized).Its molecule bound not easy to oxidized so the response efficiency defined in USP (united state pharmacopoeia )its response efficiency not less then 85% and not more then 115% . BQ run as control sample in the References of Sucrose .And Its Calculation methods [(rss-rw ) / (rs-rw)]100.
Is This Answer Correct ? | 13 Yes | 0 No |
Answer / amarjeet kumar
Any sample in TOC analyzer is being purged with inert gas aftrr mixed with an acid and 1,4 benzoquinone is the toughest as said above to get oxidised others may get easily oxidised.
Is This Answer Correct ? | 8 Yes | 0 No |
Answer / dignesh udwadia
sucrose is high oxidation and 1,4-benzoquinone is vary low oxidation to cover higher and lower oxidation range we are used above mention material for calibration.
Is This Answer Correct ? | 6 Yes | 1 No |
Answer / umamahesh
sucrose is high oxidation and 1.4- benzoquene is very low oxidation to cover higher and lower range
Is This Answer Correct ? | 2 Yes | 0 No |
Answer / venkatesh palla
1.In the TOC Calibration Sucrose working as a test solution
and 1,4 benzoquinone working as a standard or Control
solution.
Is This Answer Correct ? | 12 Yes | 21 No |
How to do spike of aflatoxin in peanut to get maximum recovery
what is difference between UV - VISIBLE MODEL NO like 1600,1601,1700 etc ? plz explain me
0 Answers Graviti Pharmaceuticals,
What is Delay & Dead Volume
why we are using buffer solutionas as a mobile phase in hplc.
What is cut off value of solvent used in hplc
what is the difference between the Purity and Potency of drug substance
1 Answers Divis Laboratories, Graviti Pharmaceuticals,
why we measure PH of a solution in PH only why not POH ?
1 Answers Stellence Pharm Science,
What is the formula to determine the concentration of M of a solution given the % transmittance? Use %T = 43.7 as an example.
what is the balance drift?
Is it necessary to inject three replicate for accuracy in AMV.
why 2Theta value is consider in the XRPD spectra and how to consider the 2 Theta value
How to determine the EDTA content by potentiometry titration in Ceftriaxine sodium