how to find 5 kilo meter long under ground 33 kv cable
fault location if IR VALUE shows 0.05 M ohm @5000 volt.and
cable fault locator shows some time fault distance 3 kilo
meter ,3.7 kilo meter and some time 1 kilo meter? now how
to find the fault location that where is leakage.



how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm..

Answer / ruddho

Can u give me the value of 5km cable resistance.


if IR VALUE shows 0.05 M ohm @5000 volt what is it.

Is This Answer Correct ?    5 Yes 2 No

Post New Answer

More Electrical Engineering Interview Questions

if There is Short circuit in Power Transformer, what will happened to Buchholz Relay.?? How Buchholz Relay will respond.??

2 Answers  


Is there any reason that a vertical motor can not be mounted horizontally ? I happen to have one and would like to use it horizontally to save money by not buying a new horizontal motor.

1 Answers  


If u take a kWh reading in 11 kV HT and 440 LV side at same time in yesterday today , then why LT consumed units 3-4℅ high as compared to HT units

1 Answers   Brigade,


For a Potential Transformer(PT), the primary neutral terminal must be grounded before energization. Why....? What will be heppend if we energize the PT without grounded the primary neutral point? Why..........?

2 Answers  


if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side

0 Answers  






What is EHT(Abrebiation,Function,Voltage Regulation & how it works?

2 Answers   Adhunik,


what is the difference between transformer and amplifier ??

5 Answers  


how do prepare ongc exam.how is it question model.i am electrical. which part covering in electrical.tell me

0 Answers   ME,


what questions will be asked for 11/33KV licence interview APSEB hyderabad. Can any one share question and answers.

0 Answers  


any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?

0 Answers  


How do we calculate transformer oil in liter from the rating of the transformer.

0 Answers   BARC,


why we use REF and Differential Protection in one transformers?my doubt is both protections are operated in internal fault only.why we want to use 2 protections?please clarify.

7 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)