which things consider when the calculate the area of the
flat?
Answers were Sorted based on User's Feedback
Answer / sanjeev kumar jain
The weightage of the common areas such as passages/ lift/
stilt/ garbarage chutes/ ducts/ wall area has to be
considered to arrive at a fair SBUA.
For BUA the common amenities are not taken into account and
for carpet area , the wall area is reduced from the builtup
area.
Is This Answer Correct ? | 2 Yes | 1 No |
Answer / mitesh patel
We should consider built up area, super built up area and
carpet area all together to find area of the flat.
Is This Answer Correct ? | 0 Yes | 3 No |
what is slope provided to floor?
What is the difference between gray swr pipe & red swr pipe
what is density on steel bars?
Gidc technical que paper
during site visit if i find voilation going on,what can i do,how i act?
what is mean by compressive strength
pls tell estimate for 1 kilometre length random rubble masonry 0.90 metre height 0.600 metre width
Minimum and maximum size of the building components
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
how to diffenentiate the fixed beam and simply supported beam in the execution while reading the drawing and how the reinforcement detail will be differ for the above.
Please Clear My doubt . We Can Design the size of the beam by manually by the Length of the beam...What is the technique adopted
what is the concrete mix design ratio of railway sleeper??????