Answer / sag_autoenggr

cot ( phi) - cot ( theta) = b / l

where,
b= dist. Bet. The chassis intersection points of front axle.
l= wheel base

High speed gear is obtained in the case of sliding mesh gear box when a) Motion is transferred through the clutch gear to lay shaft gear b) Main shaft is coupled to the clutch shaft c) Smallest gear on the lay shaft is engaged d) Largest gear on the lay shaft is engaged

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

what is the syllabus for the rrb sec. eng. posts iam from automobile engg.

0 Answers   RRB,

---

i want to make higher studies in automobile (me) how i can select the college and where i have to contact them, syllables

1 Answers  

---

i had applied for 6 categories for rrb section engineers posts 2 different rrb boards 2 those i was eligible of an single notificatoin. do i need 2 write different exams or single exam

0 Answers   RRB,

---

Slip joints are provided in the propeller shaft a) To adjust the inclination of the propeller shaft b) To adjust the length of the propeller shaft c) To prevent the whirling of the propeller shaft d) To adjust the up and down movement of the rear axle

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

---

why we are using oil with petrol in two stroke engines but not in four stroke engines(two wheelers)?................

11 Answers   Ford, GE, MAHINDRA,

---

What happens if you use petrol in diesel engine?

0 Answers  

---

When we run the report j1ifr ( pending 4(5)a challan )this report can we convert in excel sheet.

0 Answers   Carraro,

---

Explain the concept of hit and miss governing in IC engines.

0 Answers   Ashok Leyland,

---

What is the reason for emitting the white exhaust smoke during start of the vehicle?

0 Answers  

---

how to calculate 500 k.v.a diesel generator efficiency

0 Answers   Cummins, TATA,

---

Explain the consequences of using bs3 engine fuel with bs4 engines.

0 Answers  

---