Answer / rushi n. gajjar

dyn5 test of transformer in which some condition like U,V AND W. primary and sec. side we check
1U2W=1U2V;
1W2V<1W2W
1V2V=1V2W we found all this condition in dyn5 test.
dyn11 is vector diagram of 3 phase xmer phase difference 60 degree between R ND Y same way....

Answer / kobena wiredu

DYn means a delta-star connected transformer in which the primary is delta connected and the secondary is star connected. The number that follows tells us the position of the Red phase of secondary relative to the primary using the clock (primary Red phase at 12oclock).So Dyn11 means secondary is on the 11 oclock line and hence leads the primary by 30deg since anticlockwise is the convention.To convert from one DYn to the other you need to change both primary and secondary connections. You do this by drawing vector diagrams. By using vector diagrams i find that converting from Dyn11 to Dyn5 means: Change ABC to ACB and change abc to cba.

Answer / hemant dehariya

In DYN 11 & DYN 5 is DYN 11 is HV voltage is lead from LV by angle of 30 degree and in DYN 5 HV voltage leg fron LV voltage by 150 degree.we can change vector group from DYN 11 to DYN 5 by change primary winding connection of transformer.

why distribution transformer is uesd in Delta/Star formation?is there any significance in doing this?If yes then breif?

3 Answers  

---

why would amp draw on neutral wire be as much as amp draw on the hot leg.

0 Answers  

---

In my home i am getting too much electricity bill (more than 4000) but I am very much sure that we are not consuming that much. How i can check this ?

6 Answers  

---

single phase power supply give to separate one steel coup with water, what reaction create

0 Answers   Turbo,

---

why three phase capacitor takes unbalanced current in capacitor bank?

0 Answers   Aggreko,

---

Why use in ht motore

0 Answers   ACB Group,

---

why energy storing capacity of magnetic field is much higher than electric field ?

1 Answers  

---

If a air condition consume 2.50 to 3.00 amp then how much it will consume in watts if it is running 10 hours out of 24 hours????

0 Answers  

---

a power supply to be constructed from voltage cells is required to provide Max. 20A Current with a terminal voltage of 6v.Several voltage cells are available each of which has terminal voltage of 1.5V & each of which can supply a max current of 5A .the no of cells required will be ??

5 Answers  

---

No load tap changing transformer working

0 Answers  

---

Please give me a ansver for why currant transforme noe point should erthing

1 Answers  

---

What is the difference between electronic regulator and ordinary rheostat regulator for fans?

0 Answers  

---