what is the cast iron grade of composition of c-3.06% , Mn-
0.48% , Si-2.38% , S-0.088% , P-0.092% , Cr-0.12% , Ni-
0.012% , Mo-0.00%
No Answer is Posted For this Question
Be the First to Post Answer
How 'saltation velocity' is used in designing pneumatic conveying systems?
what is the PH value for boiler water.
What are the apt definitions for apparent power, active power and reactive power?
What is the characteristic length for slab?
What is a good device to use for obtaining viscosity data for a non-newtonian fluid?
How are plate heat exchangers used in an ammonia refrigeration system?
How much will be the increment for postal assistant yearly?
QUANTUM CHEMISTRY AND CHEMICAL ENGINEERING - EXAMPLE 31.5 : In a wavefunction, let P(x) = A cos kx + B sin kx. By using the boundary conditions of x = 0 and x = l, where P(0) = P(l) = 0, prove by mathematical calculation that P(x) = B sin (npx / l) where p = 22 / 7 approximately, n is a rounded number. A, B and k are constants.
The job profile as a Service Engineer?
What are some of the consequences of an undersized kettle type reboiler?
NATURAL GAS ENGINEERING - QUESTION 26.1 : (a) In natural gas pipe sizing, the length of the pipe from the gas source metre to the farthest appliances is 60 feet. The maximum capacities for typical metallic pipes of 60 feet in length are : 66 cubic feet per hour for pipe size of 0.5 inches; 138 cubic feet per hour for pipe size of 0.75 inches; 260 cubic feet per hour for pipe size of 1 inch. By using the longest run method : (i) Find the best pipe size needed for the capacity of 75 cubic feet per hour. (ii) Estimate the suitable range of capacities for the pipe size of 1 inch. (b) The maximum capacities for typical metallic pipes of 50 feet in length are : 73 cubic feet per hour for pipe size of 0.5 inches; 151 cubic feet per hour for pipe size of 0.75 inches; 285 cubic feet per hour for pipe size of 1 inch. By using the branch method find the best pipe size needed for the capacity of 75 cubic feet per hour when the length of the pipe from the gas source metre to the appliance is 52 feet.
What are the assumptions made for kynch theory?