Answer / mahadev

increase the current on same load.

Answer / sankhajit das

Increase the current on same load.So, heat will increase in
same load.

Answer / suri

The demand on the system will increase and also surcharges
for the low power factor to the EB

Answer / satish panchal

If Ht motor operate in low PF, Current will incresed and
motor winding will start heating. Due to excess temp chance
for motor wdg burning and also chance for damage the
bearing.

Answer / gurvir

OK, I know current will increase. But in HT supply current
will increase marginally. So,it does not have much impact.
I wanted to know, what major problems may arise or what
harms it will do to equipment or anything else.

Answer / sumit

Volatge will go high in this case
and load to be increased on ht side

hi frnds.....anyone get any reply from HPCL. I HAVN'T.....B,COS written will b on FEB 17 th.

1 Answers   HPCL,

What is the need for a controller?

0 Answers  

What are test values for an 63 KVA and 100 Kva Distribution Transformers for the following typical tests 1)Magnetic balance 2)Short circuit test 3)Open Circuit test 4)Vector group confirmation test .please give me the standard values for all the above tests.

0 Answers  

what is effect of 5amp fuse on 2mva pry protection of transformer

0 Answers  

Why no-load primary current is very small as compared to full load current in transformer (as 1% of full load current?

5 Answers   NTPC,

diffrence between abcb and mocb

1 Answers   UltraTech,

what is mean by PIR in circuitbreaker and give me detail of that?

0 Answers  

what is neutral grounding? why is it required? what is neutral grounding resistor and how is its value calculated??

11 Answers   NTPC, ONGC,

block diagram of 2 ups system connected in parallel mode?

0 Answers  

what happens to a turbo alternator if it get trip and 1 out of 3 poles of circuit breaker in close condition

1 Answers   wbsedcl,

what do you understand by dressing a HT/LT pole

1 Answers   Federal Polytechnic Nekede,

want happens when a dc is given to a commutator

2 Answers