what is rotating transformer? what is the uses of it?i mean
applicaitons?
Answers were Sorted based on User's Feedback
Answer / mukillan
The induction motor is called rotating transformer.because
stator act as primary winding as well as the rotor act as
secondary winding.Induction motors are widely used,
especially poly phase induction motors, which are frequently
used in industrial drives. it is converts electrical energy
into mechanical energy
Is This Answer Correct ? | 58 Yes | 7 No |
Answer / viren
it may be the induction motor bcoz induction motor can be called as rotating transformer with shorted circuited secondary......
Is This Answer Correct ? | 21 Yes | 3 No |
Answer / baljnder singh
Induction motor is called rotatig transformer.It has also two
winding like transformer .It is used in maily
industries ,houses etc.
Is This Answer Correct ? | 6 Yes | 4 No |
Answer / sam
Rotating Transformer is a device to transfer electrical energy AC from stator to Rotor in AC and opposite/reverse.
Basically, it send AC supply to rotor by AC supply from sec. So its not use brush/slip ring. This rotating transformer is used for synchronous motor mostly. More question u may contact me WA +97433450404
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / prabakaran
transformer: convert low voltage to high or high voltage to low..........
rotating transformer is one of the type to do step up or step down.but it ll not convert from electrical energy to mechanical energy.....
uses of this: to avoide wear.
Is This Answer Correct ? | 0 Yes | 7 No |
Why is a thicker conductor necessary to carry a current in A.C.as compared to D.C. ?
what is stper motor.what is its uses
what formula can be apply to calculate the No of rtrand of a cable. ?
why in isolation transformer we dont get any shok?
In secondary transmission i.e., in distribution side, supply for homes are connected through different phases in order to balance the 3 phase load. But in practical we saw nearby house doesn't have power due to single phasing. But other two phases give supply. How it's possible? it doesn't make "single phasing"?
Three phase star connected PT transformer primary side one phase fuse is blown what will be the output in secondary side(Secondary side also three phase star connected)
wich type of cable is selected for wiring of 20hp motor?
Where should the lighting arrestor be placed in distribution lines?
What is the formula to find out the kvar required to improve the powerfactor from .85 to .99 at 1500kw, 415v.
IF we have three 30KW motor, these motors are connected in DOL, star-delta and VFD respectively, what will be the fuse rating for the above three?
what is XF 200/240 V AC for Drawout Breaker.
Can we use LT(150 sq. mm) cable in place of HT (120 sq.mm.) cable.?