Answer / hiren patel

Vapor lock is when the fuel in the fuel line becomes too hot from engine heat (along with outdoor heat) and causes the liquid fuel to turn into a vapor state. The engine won't run with it in this state as it can't be sprayed and controlled by the injectors and pressure regulators properly.

Usually there is enough fuel flow and pressure to keep this from happening, but if the fuel pump, pressure regulators or injectors are going bad, there may not be enough pressure in the fuel line to prevent it. Also, if a fuel line is too close to an exhaust pipe or hot part of the engine and not properly insulated, it can cause this.

So, it really depends on a lot of things, properly working equipment, good engineering design, and good fuel all make a difference.

Insulating your fuel line wil help, also making sure your fuel system is in good working condition will help prevent vapor lock.

Usually letting an engine sit and cool down for awhile will allow the fuel to turn back into a liquid and the car will run again.

Hello sir! I hav read the above discussions about PSU.I hav 72% aggregate in Mechanical bt i do had a back in 1 subject,so m i too eligible for PSU?

0 Answers   Knoah,

---

Which rays are produced by cobalt-60 in industrial radiography ?

0 Answers  

---

what happens at an equipment buyoff?

0 Answers  

---

Why gas turbine power plant needs efficient compressor ?

0 Answers  

---

Hello i want to design a portable 1/4HP pressure washer pump like elgi reciprocating pump which are being used in service station.what are the design aspects to taken in to consideration for making new pump.

0 Answers  

---

what is the fitter...?

2 Answers  

---

fd fan working

2 Answers  

---

• What do you consider to be your job's most important assets?

1 Answers   Petro Star Mount,

---

how to control ovality in internal diameter

1 Answers  

---

• Do you think you are overqualified for this position?

1 Answers   Petro Star Mount,

---

what will be the velosity of a water at in the pipe of 6 inches which is situated at the bottom of 10 mtr tank ?

1 Answers   Essar,

---

how i can calculte the lenght of a ring dia 27 mm.

5 Answers   TATA, WWE,

---