Answer / k.prakashchandra

Use a wire gauge or measure the diameter using a screw gauge
and find the corresponding number in the chart.

can you use 400 volt 3 phase and neutral and earth equipment on 440 3 phase and earth supply safely and if so how?

2 Answers   Maersk,

---

can we run three phase motor by single phase? and what happens if we do this

8 Answers   Kirloskar,

---

what was the function of the auxillary relay?

3 Answers  

---

what is diffrances between fuse and breaker protection? which one is best?

2 Answers   Essar,

---

What are the fire Estingushers use in electrical fire?

3 Answers  

---

The loads are connected with phase and ground then why current flow as the loads ?

0 Answers  

---

Why is the starting current high in dc motor?

0 Answers  

---

what happens in the short circuited secondary transformer,if the resistance of the short circuit is increased gradually?

0 Answers   IIT,

---

The unit of quantity of electricity is the:(a) volt(b) coulomb(c) ohm(d) joule

1 Answers  

---

Cables Construction hi friends, 0.6/1/1.2 kV LV , DC and Control cables are concentric copper conductor what does its means and what is the use of concentric copper conductor,and are this with copper tape shield or copper screening, ? thanks

0 Answers  

---

what is the difference between general inverter and solor inverter clerly explain plz

0 Answers  

---

what are the types used for alternator earthing,what will happen if more than two alternator is working in parallel with each having own system earthing.is there any possibility for circulating current in between two system.

3 Answers   BEL,

---