I have CNC Turning lathe,while doing electrical preventive
maintenance what should I do & please brief me plan &
shedule for the same.
Answer / a.b.utturkar
pl do earthing properly and if neutral shifted then connect
to another earthing. you will get mini. en voltage
| Is This Answer Correct ? | 0 Yes | 1 No |
What are the classification of Servo Motor?
What are the types of feedback oscillators?
What is the mulplying factor of trivector meter (11kv) having ct ratio 100/5 amp.
How to calculate the fuse rating depend upon the DC circuit?
why ten delta testing is carried out on power transformer
Y phase plates are used in transmission line??? what is there need???
Ferranti Effect says that voltage at the receiving end is higher than that at the sending end. How is it possible?
we have 350 kva capcitor bank which is not showing KW. dose capacitor shows kW OR not.
How many Cylinders are there in Diesel Generator?
1.Whats the use of GNAC(Generator Neutral Accessory Compartment) 2. why generator or any other system require Neutral Grounding and not Phase grounding 3. what happens if any one of the phase is grounded. 4. if 15kv is grounded directly what will happen, why it should not be grounded like that 5. use of of NGTR(Neutral Grounding Transformer and Resistor) for grounding is helpfull and how
5 Answers BEMCO, CSS, Powergear,
please explian how may types of maintenance works.
what is feeder?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)