Answer / baldo2010

the time depends on the Power Transmitted and the lenght of
the transmission line from generation to receiving end.

Answer / jaggannath swami

Its depends on from sending end to receiving end by whta type of cable or conductor are used In overhead line Ht Power from 132kv to above are as per our record 30sec per 10km and lv side upto 33 kv is .25 sec per kilomers

Answer / madan kumar

exactly 5.32seconds. if you have any doubt calibrate the
stop watch.

What is difference between incomer & outgoing type Vaccum Circuit Breaker?

2 Answers   VBG,

---

Explain what is CBCT.

1 Answers  

---

what is the meaning of 5% droop or 7% droop in AVR?

0 Answers  

---

State uses of different types of stsrters with different capacities of motors as below: a. up to 5HP b. above 5hp to 10hp c. above 10hp to 20hp d. above 20hp

0 Answers  

---

how to write program by ladder logic in case of PLC operation

3 Answers   Gridco, Sofcon,

---

how is the cable tray designed & how its total length is calculated for an Industrial plant Say for Ex. (500KW Motor Load)

0 Answers  

---

Can i connect all earth pits in ring system..., And wat IS 3043 says...please help me

1 Answers  

---

How to model two generators into a single generator ? Eg. two generators connected to a bus, would like to model it as a single generator connected to a bus.

0 Answers  

---

Why Nutral CT rating for Earth Fault Protection of Transformer neutral shall be 20% of Full load Current of Transformer

2 Answers  

---

How to Make relay co ordination chart for a Electrical power distribution of a plant

0 Answers  

---

sir, Is their any measuring unit of knoking? please explian?

0 Answers   Kirloskar,

---

Why tripping not occur when the transmission lines (11KV & above) breaks? Doesn't we provide earthfault protection for it?

1 Answers  

---