how to calculate power loss cost of aluminium conductor and copper conductor?500v,100A,68mm area squre busbar.

1 Answers  

---

how to store the thunder power?

1 Answers   Voltech,

---

How to design the no. of ceiling fans required in 5mtr X 10 mtr X 3 Mtr hight room?

0 Answers  

---

the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?

0 Answers  

---

Why do you use an isolator on both sides of the circuit breaker? ( shortly answer)

2 Answers  

---

---

Is it possible to increasing the real power generation by reducing the reactive power in power generation plants

3 Answers  

---

What are the advantages of thermal power plant?

0 Answers  

---

what is the solution for meger test failed the MV cable?

1 Answers  

---

what is positive,negative and zero sequence in power system?

4 Answers  

---

why transmiision rating in kva?

4 Answers  

---

There are two nos of 33Kv/11Kv 5MVA transformers conecting through HT cable from substation having metering at substation itself.One transformer used at a time another remains stand by.Further 11 nos of 11Kv/440V transformers are attached on it and each transformer is having its own Power factor correction panel.Now one 33/11Kv transformer at no load condition/Stand by condition is having power factor in leading side upto 0.21 and while when another tranformer at same situation have power factor in lagging 0.42. Now one thing is clear that transformer one is having 1.5 Km long 33kv cable due to that PF goes in leading side and another is having only 250 mtr length remains him lagging. Now i want to know that how i can maintain the Power factor at no load/ stand by position though both are behaving in seperate manner.

1 Answers  

---

Do inductive loads have distorted current waveforms ?

0 Answers  

---