An alternator is started without excitation then how much
voltage it will produced at strating at full rpm??
Answers were Sorted based on User's Feedback
Answer / alpesh
dear sir, thanks for answer.. and this 4.5 percentage
voltage is due to residual magnetism in rotor of alternator.
right??
Is This Answer Correct ? | 2 Yes | 1 No |
Answer / r.veeramani
it will produce 4.5 percentage of the rated voltage of the
alternator.
Is This Answer Correct ? | 0 Yes | 1 No |
Answer / vinothkarthick
hi friends what you said is right.i having a guess that
without excitation it will run as induction generator...is
it right ah????help me!!!!!!!!
Is This Answer Correct ? | 1 Yes | 2 No |
Answer / alpesh chauhan
hey u r right but my question is just running alternator at
full rpm without charging the breaker... so it will not draw
any power to run as induction generator
Is This Answer Correct ? | 0 Yes | 1 No |
why designer use kva rating instead of kw in transformer rating???????????????
How vaccum is formed to create a vaccum interrupter or anything related with vaccum?
am commissioning the trafo without connecting the neutral therefore unbalance will occur what is the alternative solution for this?
How to take Transformer oil Break down voltage test?
Why we called L-G fault as line to ground fault why ground? suppose if a line falls on building roof then can we called these fault as line to roof fault? please explain why ground term is used here?
1 ton AC takes how much current( starting & stable)
how we check vector group dyn7
why write 500v on line tester (Test pen)
A Generator is in running condition and Rotor earth fault alarm is coming.How to check on line(i.e in running condition) whether there is actual earth fault in rotor or not.
What will happen if the 50HZ Transformer is connected with 60HZ power Supply
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
how we can calculate power factor without knowing current in 230v 100w load ?