Answer / iamdon

The site is situated in Kota(Rajasthan).
Dear prashant are you mean to say about the same site...?

Answer / prashant

Katchh

State four criteria's for selection of site for nuclear power station.

1 Answers  

---

how we select the fuse and OLR rating for 3 phase induction motor from 1HP TO 100 HP?

2 Answers   Thermax,

---

what is impedence in transformer

2 Answers  

---

DGs fuel and lube oil filters are not equal to one another.Why it is so.For example one MTU enginee fuel filter is one and lube oil filter-02nos other DGs are more.Please explain

1 Answers  

---

What is the meaning of CT 40/5, 100/5 or in HT lines 100/1 ????????

3 Answers   Amex,

---

why induction motor having low power factor at starting time and high at full load.

6 Answers   BARC, HPB,

---

We say that if voltage in a power system is increased,for a constant power the current will decrease (by P=VI). isn't this in disagreement with the ohms law(I propotional V;resistant const.).Since the resistance of transmission lines remains constant,shouldn't inc in voltage cause inc in current across the transmission line? I have read many articles across the net but still couldn't this figure this out. :( Guyz plz assist me with dis..:)..

4 Answers  

---

There are 2 Flip_Flop with logic between them. Given Clock to Q delay, logic prop. delay, set up and hold times specify maximum clock frequency of system. What happens if second output fed back to first input. Any changes? What happens with timing if second output is fed back to logic between the flops? Good Luck!

1 Answers   Qualcomm,

---

How much is the starting current for HPMV lamps. How many lamps can u wire in a circuit

1 Answers   Technip,

---

WHAT IS EDDY CURRENT LOSSES AND SKIN EFFECT LOSSES IN ELECTRICAL ENGINEERING

1 Answers   GAS,

---

How to checked frequency drive output voltages?

0 Answers  

---

How to calculate the Harmonics losses in terms of cost/unit.

0 Answers  

---