What will be result if we connect LT votage to the terminal
of HT Transformer?
Answers were Sorted based on User's Feedback
Answer / m.dharmaraj
i think,nothing will happen,because transformer acts as
step up.
Is This Answer Correct ? | 3 Yes | 1 No |
Answer / arunkumar
The LT VOLTAGE will stup up depens upon the HT transformer
winding ratio
Is This Answer Correct ? | 2 Yes | 0 No |
what will happen when power factor is leading in distribution of power?
10 Answers AMET, JTO, Power Grid,
how to test the ht machines?
different between highvoltage & lowvoltage source
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
Please explain me about Relay curves and their sources to read ?
why the rotor current becomes in steady state during high slip region? please verify with equations.
How to take the Vector Group Test in Transformer? What is the purpose of doing Vector Group Test?
WHAT IS SITTING AMPS IN OVER-LOAD RELAY FOR 1PH OR 3PH MOTORS?IF ITS NAME PLATE GIVEN MAX AMPS 10AMPS?
why a three phase induction motor cannot run at synchronous speed ?
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
What is lifting power for 1 wb/m2 and 1 A magnet?
Sparking occur when a load is switched off because the circuit has high – a.) Inductance b.) Capacitance c.) Resistance d.) None