Why does inductor is connected to dc supply? or what is the
role of an inductor when connected to DC source?
Answers were Sorted based on User's Feedback
Answer / princealekota
Inductor used in DC circuits is for safety purpose. When
inductor is connected on DC circuit storing and decaying is
happend in specific conditions.
when current suddenly increases then inductor produces self
induced emf opposing the current then voltage across L is
-Vemf. and when current becomes stable inductor will not
oppose the current and voltage acreoss the inductor is zero
and act like a normal wire or just shorted since freq in DC
is zero.
so final thing is, inductor will not allow the changes of
current in DC circuits
Is This Answer Correct ? | 47 Yes | 1 No |
Answer / prabhu
You almost got the answer. In DC since frequency is zero the
current flow freely. But the main purpose of using
inductance is to restrict the harmonics. In case of
harmonics there is a frequency element playing a role. since
inductive reactance = 2(pi)fL The inductor offers resistance
to this harmonics and thus reduces the harmonics.
Is This Answer Correct ? | 16 Yes | 3 No |
Answer / c_elavarasi@yahoo.com
In DC supply,we wont consider freuency,therefore when
frequency is zero,inductive reactance is also zero.then
what is the purpose of connecting inductor to the DC
source. i dont know the exact answer.
Is This Answer Correct ? | 10 Yes | 8 No |
what you have to see after one week or month from the day of installation of transformer ?
what is electricial and mechnical interlock.
9 Answers Control Dynamics, EFS, HP,
when voltage increases then current also increases then what is the need of over voltage relay and over current relay? can we measure over voltage and over current by measuring current only?
why free wheeling diode is connected across inductive load
16 Answers NTPC, Omaxe, Wipro,
in transformer the unit of power is in kva why?
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
The Source internal resitanse Rs , When equal to Load resistance RL, the maximum transfered is of _____ % of input power?
what do you mean by puncturing of insulator by ice -coating?
in alternator what is use of AVR ? how AVR is operating either AC or DC?
what will be the maximum winding temperature of 6.6kv HT motor 450kw, Full load current 49A. 50Hz Frequency.
why after termination of HT cable armoured earth connected one end, why not connect other end.pls tell me correct answer.
how to check the insulation for motor using megger?