iam working as a electrical engineer. i want to know about any license or certi

iam working as a electrical engineer. i want to know about
any license or certificates regarding my field.

for my carrier and ti improve the knoweledge.,,,
how we get that..and what procedures.........

pls help me

Question Posted / remodeen

1 Answers
4194 Views
I also Faced
E-Mail Answers

iam working as a electrical engineer. i want to know about any license or certificates regarding my..

Answer / rider

You can Apply for Electrical Supervisors license ..issued by
the Electrical Licensing board.Supervisors license will be
an added advantage for your field.An interview will be
conducted on your knowledge in Field covering
cabling,Designing,switchgear,Earthing and LT as well as HT
installations
License will be issued depending upon ur performance..

Is This Answer Correct ?

4 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

i need to calulate the cable size when watts are mentaind wat z the formula

1 Answers

1.what is difference in maintain Hz again Hz in USA ? 2.how to calculate the battery AH? 3.why are yearly maintained in transformer how many tests in required?

0 Answers Areva, Google,

what is the function of avr when synchronous generator act as synchronous motor

1 Answers

Difference between divercity and power factor

1 Answers

When we synchronize the Generator BKR with TIE BKR then Gen BKR is hold but TIE BKR is Tripped on Non directional over current but when TIE BKR is Syn. with Gen. BKR then no fault occur so what is the problem

1 Answers ABB,

How much Fault current can be contributed by a motor?

4 Answers

what happen if the load connected to the induction motor is taken away? the same question for synchoronous generator in synch i think that the the exitation voltage will appear on the terminal only if so plz answer me

0 Answers Escorts,

can we connect transformer with star conected secondary to delta connected primary in series?

1 Answers

a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5

0 Answers

in india why the generating voltage is like 11kv,22kv etc

1 Answers Alstom, Ford,

why are we adopting 132kv,220kv for transmission rather than using 440kv at all transmission lines as it gives lower losses?

2 Answers APGenco,

What is static Device & Mechanical device? Is transformer a static device?

5 Answers ABB, Emco,

For more Electrical Engineering Interview Questions Click Here