Answer / masud molla

actually the freq. corresponding to 3 db magnitude is considerd as bandwidth of signal. At this freq. the power of the signal is reduced to half of its max power or the attenuation caused by the system to the signal is such that the magnitude reduce to square root of half of the max magnitude of the signal. this is taken as standard refernce freq. beyond which the responce is not very important from the system analysis point of view.

Hiiii....Friends Which one is right? 1.All transducers are sensors but all sensors are not transducers.(or) 2.All sensors are transducers but all transducers are not sensors..... Plzzzz tel me guys...thank u in advance...

2 Answers  

---

what is the difference between electrical and electronics technicions and what they do/ and for what porpose?

19 Answers   HCL, IBM,

---

why 20logA is used as voltage gain and 10logA is used as power gain

2 Answers   ONGC,

---

What are the differences between voltage and current controlled devices?

0 Answers  

---

Draw the frequency response of DARLINGTON PAIR

0 Answers  

---

---

what is the difference between the ss7 and ip,and why we go for ip structure over ss7

0 Answers  

---

Explain why bjt is called current control device?

0 Answers  

---

what is diffractive quality factor?

1 Answers  

---

wat will happen to the windings if the required current is not given to a stepper or dc motor , but voltage is constantly applied to it below required current??

0 Answers   Freescale Semiconductor,

---

Why 50Hz power supply is standard?

2 Answers  

---

Please send me RRB Bhopal last 5 years solved Question paper on amrita_jain2001@yahoo.com

0 Answers  

---

Desktop comes in which layer?...

1 Answers   Cisco,

---