why we use the fuse
Answers were Sorted based on User's Feedback
Answer / ddbindia
fuse is used for following this reson;- breking the supply
of eqipment at the time of taking more curent raspect
rating curent of eqipment.
Is This Answer Correct ? | 15 Yes | 2 No |
Answer / nadeem riyaz ansari
When higher current than the rated current of circuit flows then it produces more heat ultimately temparture of fuse wire ( having low melting point )increases which melts/breaks the metal wire Hence it is used for safety of circuit to avoid any damage to circuit component
Is This Answer Correct ? | 8 Yes | 0 No |
Answer / trilok gupta
to saved the equipments when the current is very high & cut
the flow of electricity when necessary
Is This Answer Correct ? | 7 Yes | 2 No |
Answer / ashok
to saved the equipments when the current is very high & cut
t
to save the equipment when the current is very high & cut
the flow of electricity when high currents or voltages come
Is This Answer Correct ? | 3 Yes | 2 No |
Why diodes should be connected in antiparallel with thethyristors in inverter circuits?
What are the main purposes for which a cc amplifier may be used.
Why every time that I hit the microphone or when I speak louder the amplifier is switched of?
The coefficient of coupling between two air core coils depends on
Explain the approximate cost of the corrosion penetration monitoring system(cpmp)?
What is the current flowing through BTS? Pls explain?
Define what is the effect of temperature on extrinsic semiconductor?
what is reconfiguration of E1
Why series inductor and l-section filters cannot be used with half-wave rectifiers?
how u will measure the polarisation of antenna?
Draw the circuit of cb configurations using npn transistor.
what are differential gain and common-mode gain of a differential amplifier?