Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
2488In transmission line the line power loss only accured at resistance the inductance and capacitance wont consume power is it correct?
2 4616sir, why alternator output is connected to delta side in to generating transformer? any reasion?
3 7550sir, Two different rating of generator going to connect parallel, can it set same DROOP or different. Why? Please explain
2 7090generally in LT and MV motors we are using 3.5Coresx16,25,35,50 etc cable for supply.although motors is earthed at two point and having all protection.then why we are using that 1/2 core for earthing the motors.while in HT cable we are using only 3core cable for motor supply.generally lt and mv motors are delta connected and ht motors having star connection.whethere it is having any relation with winding connection( star or delta).all motors i am talking about are dol only.can anybody solve my confusion.thanks...
1931
How we calculate the size of ht cable for any transformer
The concrete slump recommended for beams and slabs; is?
what happen when increase or decrease size of lamp,light.glass.
What are the advantages and disadvantages of jfet over bjt?
Can I use distributon class/transmission class Lightning arresots for protecting the building? If not why please explain?
What are annotations? What are assertions? why they are used why not if-else?? what is normalization? what is QuickSort? what are Avl trees?
Give some example of fault limiting devices?
sir, 3phase induction motor takes different pf and different KW in three phase while running,explain reason
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
What is chroma?
what is your experience in developing technical specifications?
Explain the difference between hydraulic oil and engine oil?
What is the PLC configuration in Cement industry?
what should be the PCC ratio to construct a plinth of (40x40x4)ft...??also its estimated cost??
what is a synchronizing lamp ?