Interested to Buy Any Domain ? << Click Here >> for more details...
-
Civil Engineering (5086) - Mechanical Engineering (4456)
- Electrical Engineering (16639)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
What is the Chemical Formula of Mineral Oil used in Transformer. It is Challenged for all Chemical Engineers.
6 25848how i decrease the neutral to ground voltage , thats i read 7v on my digital meter.i dont know about my earth pit.
2 4621why we are using the 2 slope in differential relay?but in busbar differential we are using only one slope. what is the reason.
1 3955in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
1846hi to all,i done ccna,now im looking job,but it is very diffcult to get job in networking field,.........i dnt know what im doing wrongly,kindly help me and give the proper way...i have so much of interest in this field only
1918i had applied for 6 categories for rrb section engineers posts 2 different rrb boards 2 those i was eligible of an single notificatoin. do i need 2 write different exams or single exam
RRB,
2543what happens if number of poles in stator and rotor windins of slip ring induction motor are not same. Will it rotate near to the synchronus speed defined by stator?
GATE,
1 4945
Can any one know what are the symbols at the down (below) the analog ammeter??? there are 4 symbols which are they ?????
Which type of key is used between shaft and pulley?
Help need in transformer !? Hello Friends The parameters of 2300/230 v 50hz t/f is R1=0.286 ohm R`2=0.319 ohm Rc=240 ohm X1=0.73 ohm X`2=0.73 ohm Xm=49.2 ohm Secondary Load impedance ZL=0.387+J0.29 solve the exact equivalent circuit with normal voltage across primery.. I know every thing but i cant find CURRENT I1=? and I`2=? Please help me give solution or only Formula please please...
What is power factor why we should maintain the power factor unless what will happen
what is the calculation of selection ofan capacity is 12000m3/hr.
What is heating effect?
what are problems caused by the pdu in rack server
can mini-curcuit supply MIL-tested transformer !
how to calculate stiffners position and size in transformer design
how to calibrate 0- 150 psi presure gauge by dead weght tester
How work the mobail vibrator
Is it possible to implement Restricted Earth Fault protection for a transformer without neutral CT?
what are the preventive maintanance actions taken for air circuit breaker? please answer me
What is 3 element control system
draw diagram of earthings
