how to find the percentage for minimum reinforcements as per IS:456 for beam , column, slabs.??
1 6055how we can improve power factor from 0.8 to 0.85 or 0.9 & how we identify its either lag or lead ? thank you
7 12519in three phase with neutral connection, what will happen,if the neutral is in open condition with single phase distribution panel ?
2 3562What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?
4 6379
What are the uses of windmill?
There are n points and each point enclose with x and y axis form a rectangle and find the point using a program which forms the smallest rectangle?
As we know diode work on both negative and positive but converting ac into DC we have to given a/c from negative of diode or positive side.please give me answer.
convert 140 N.m/cm^2 to N.m/mm^2
what is concrete canvas?
where proximity sensor installed on tank in loading arm application
can i use 4 number of circuit breaker as single phase manual change over switch? if yes then how plz also send ckt diagram at nazimzamurad@gmail.com
What is the formuala to calculate the rating of motor protection circuit breaker
how open delta PT works & what is its construction?
What is the use of gap(snap)gauge
What is meant by step-up cyclo-converters?
What is the need for a controller?
"TRANSFORMER MODELING AND ANALYSIS" MEANS WHAT AND WHICH TOPICS U READ IN THIS
What are the advantages and disadvantages of screw harmatic chiller respect to centrifugaal chiller machine?
i am electronics & comm engg & appling 4 the AAI jr executive (electronics/ATC) written test. pls forward me the syllabus & old question papers.I will be very much thankful to you akil403@yahoo.com